Flow Control
Remanufactured 8700 Flow Meter Installation
April 12, 2019
10 Questions to Install & Commission Your Magnetic Flowmeter Did you confirm your transmitter has been set with the correct line size? Did you determine and enter correct flow units in your transmitter? What is your nominal flow rate expected? Nominal flow rate helps determine lower and upper range values relative to 4-20mA output, and […]
Read MoreWhy You Should Use Control Valve Positioners
September 19, 2018
Process control is a lot like baking, says Jerry Butz, Director of Engineering and Technical Support here at Automation Service. Baking requires specific quantities of ingredients and a steady supply of heat. To keep the oven at the desired temperature, your oven thermostat takes measurements and sends the data to a controller, which then turns […]
Read More